Common Electrical Problems in Your Home

Common Electrical Problems in Your Home.

 Flickering Light bulbs

Flickering Light bulbs

Problem: Flickering or blinking lights.

Diagnosis: Poor connection at some point in the circuit. If the phenomenon occurs throughout the house, the cause may also be a faulty main wire connection.

Solution: Hire an electrician to locate and repair the source of the problematic connection.

 Recessed Lights that don′t come on

Recessed Lights that don′t come on

Problem: Recessed light goes on and off.

Diagnosis: A built-in safety mode that prevents the light from overheating. This usually implies that the wrong fixture or wrong wattage of the bulb is in use or that the ceiling-space insulation is touching the recessed light fixture.

Solution: Replace bulb.

 Light bulbs are not all bright

Light bulbs are not all bright

Problem: Some lights go extra bright while others dim out, popping bulbs, electrical appliances die out.

Diagnosis: A faulty main neutral connection is causing this condition.

Solution: Have a licensed electrician immediately repair main neutral connection to prevent the deterioration of the electrical equipment.

 

 Circuit breaker trips

Circuit breaker trips

Problem: Circuit breaker trips when high-wattage items are in use.

Diagnosis: Overload on the circuit.

Solution: Either limit the use of high wattage items such as microwaves or hair dryers on the same circuit or have an electrical contractor install a separate circuit dedicated to heavy wattage appliances.

 

 Receptacle not wired correctly

Receptacle not wired correctly

 Problem: Receptacle stopped working.

Diagnosis: Loose connection due to a back-wired receptacle (wires connected directly to the back of the receptacle instead of being wrapped around the screw).

Solution: Have an electrician locate and replace all the back wired receptacles in the home. In some cases the source of the problem is not a back wired receptacle but a loose neutral connection – this too will also require professional handling.

 

 No power to your home

No power to your home

Problem: No electrical power in the home.

Diagnosis: Loose connection at the point where the power company wires feed to the service wires in your home. This faulty connection can also be located further out, somewhere along in the power companies system.

Solution: Hire a professional electrician to locate and repair the loose connection. Until the problem is fixed, retrain from using any 220V appliances such as your electric cooktop or range, central AC or electric dryer.

 

 Fishy smell can mean more than you think

Fishy smell can mean more than you think

Problem: Fishy smelling receptacle/switch.

Diagnosis: A seriously damaged electrical device.

Solution: Don’t ignore the fishy odor as it signals a serious electrical problem. Turn the power off to the smelly appliance and immediately call an electrician for a prompt solution.

 

 Whole house surge protection

Whole house surge protection

Problem: Spikes and Surges

Diagnosis: Spikes are brief bursts of extra voltage while surges are longer bursts of too much voltage. Both have the ability to destroy electronics instantly or overtime. Both can be caused by external disturbances like storms, or by automatic or manual turning off of microwave ovens, air conditioners, coffee makers or power tools.

Solution: Have electricians install plug-in surge protectors to safeguard individual electronic items against surges, spikes, electrical noise and outside disturbances.

 UPC

UPC

Problem: Sags, dips and power outages.

Diagnosis: Sags and dips are short periods of low voltage while power outages or blackouts are periods of no electric power. While sags and dips can be caused when an electrical appliance draws power as it is switched on, blackouts are usually the result of harsh weather, damaged equipment of the power company or short circuits in the home. Sags, dips and outages can cause data loss or damage to computers, answering machines, microwaves, and faxes and other electronic devices that use memory.

Solution: Have an electrical contractor install Uninterruptible Power Supply (UPS) units. UPS units operate “online” to filter out power disturbances and provide free flowing electricity during normal conditions. UPS units are equipped with battery backup systems in case of a blackout.

Most electrical problems are no DIY ventures for the dangerous nature of electricity in inexperienced hands. With any electrical mishap it is best to call your local electrician to diagnose the problem and provide an efficient and long lasting solution. We are here to help and answer any questions or concerns you have. 410-571-0900 or fill out the for linked here and we will contact you about any issue you have.

Leave a Reply

Your email address will not be published.